Threaded Mode | Linear Mode

josh.p · 07-02-2009, 11:05 PM

alright, i would like to start off by saying, i have searched a lot with no luck.

i picked up a obd1 b18b with ecu, but my car is a obd2 "96 civic dx". i did a lot of researched but i only found how to put a obd2 b18b by using the dx harness and adding a few wires.

whats the best way to do this ? i have the b18b harness also if that helps.

thanks in advance

greenej8 · 07-02-2009, 11:08 PM

CEEJAY · 07-03-2009, 04:31 PM

use your cars harness and get a jumper harness....

josh.p · 07-03-2009, 04:45 PM

(07-03-2009 04:31 PM)CEEJAY Wrote: use your cars harness and get a jumper harness....

so basically its going to be the same as if its a obd2 engine ? the only thing different would be to get a jumper harness ?

Jackie-O · 07-03-2009, 05:55 PM

yes, I believe so. You just have to get an obd2 to obd1 jumper harness.

Studshotnokc · 07-07-2009, 08:22 AM

you also have to get a b series rear mount.
like ceejay said you will need a jumper harness.
you will need a obd2a to obd1 jumper harness. you can find them on ebay or go to you local performance shop and they will be able to assist you as much as possible.